Electrical Engineering Fundamentals By Vincent Del Toro Pdf [2026]

Problem 3 — AC steady-state & phasors (18 pts) Given: Vs = 10∠0° V, series network: R=50 Ω, L=100 mH, C=10 μF, frequency f=1 kHz. a) (6 pts) Convert L and C to reactances; compute total impedance Z and current phasor I. b) (6 pts) Compute voltage phasors across each element and verify KVL. c) (6 pts) Compute real power delivered by the source and reactive power.

Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change. electrical engineering fundamentals by vincent del toro pdf

Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.) Problem 3 — AC steady-state & phasors (18

Problem 8 — Digital electronics & interfacing (15 pts) Given a microcontroller GPIO pin with output high 3.3 V (max source 20 mA) driving an LED requiring 10 mA at 2.0 V forward voltage. a) (5 pts) Calculate the resistor value and nearest standard 5% resistor to use. b) (5 pts) If the LED must be driven at 40 mA, propose a simple transistor driver (specify transistor type, resistor calculations, and protection). c) (5 pts) Explain briefly why direct MCU driving at 40 mA is discouraged. c) (6 pts) Compute real power delivered by

Duration: 3 hours Total points: 200

Problem 5 — Op-amp design (15 pts) Design an inverting amplifier with gain -10 using a real op-amp whose open-loop gain Aol(s) ≈ 10^5/(1 + s/2π·10 Hz). a) (6 pts) Choose Rf and Rin values (standard decade resistances) to realize the closed-loop midband gain -10 and justify choice. b) (5 pts) Compute the closed-loop bandwidth approximately using op-amp open-loop dominant pole. c) (4 pts) Discuss one stability concern with using very large feedback capacitances in the feedback network.